Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 4-3
Application Description for Small Operator Terminals
4.2 Programming Small Operator Terminals
You program the small operator terminals of construction type VCP in
the same way using the programming software VI Composer.
For this purpose, install the programming software on you PC.
– Start the software and select the corresponding entries for the de-
vice type and the desired communication protocol.
– Create all of the componentes of the project, consisting of languages
and a controller.
– Compile the project into a S3 file and load the file into the operating
device using the download cable.
– Connect the operating device to the controller or simulate the basic
functions without a controller connected.
4.2.1 Hardware Prerequisites
To carry out the installation, you need a basic knowledge of Microsoft
Windows. This information is not provided here. If you have any que-
ries in this regard, refer to the Microsoft Windows manuals or online
help.
Hardware Requirements Your computer should fulfill the following hardware and software
requirements, to run the programming software VI Composer:
– Pentium processor with 100 MHz (preferably 266 MHz)
– 32 MByte working memory (RAM) (preferably 64 MByte)
– 100 MByte free hard disk memory
–CD ROM drive
–Mouse
– Windows NT 4, Windows 95, Windows 98, or Windows 2000
– One free serial interface