Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-177
Standard Mode
Example for using recipes:Settings of a machine for manufacturing var-
ious products
The variables Material, Feedrate, Setpoint Value Axis 1, Setpoint Value
Axis 2, Cutting Angle and Cutting Speed can be organized into the rec-
ipe "Machine Settings for Products".
The variables Feedrate, Setpoint Value Axis 1 and Setpoint Value Axis
2 are defined as floating point numbers or fixed point numbers. The
variable Cutting Angle is defined as an integer and the variable Mate-
rial as a selection text (coded text).
The values for manufacturing the products Clamp and Shaft must be
stored as data sets. Whenever another product is to be manufactured,
the data set of the product to be manufactured next can be loaded into
the controller.
The following check list contains all of the elements that are required
and useful for creating and handling a recipe with data sets:
• The recipe itself (texts and variables)
• Data sets with data set number, data set name and variable offset
• I/O mask for the recipe
• Recipe field in the mask
• Recipe buffer (address for the data area in the controller)
• Variable Data Set Number for Transfer from operating device
Variable Value Unit
Material ST37-3
Feedrate 25,00 mm/s
Setpoint Value Axis 1 43,5 mm
Setpoint Value Axis 2 56,30 mm
Cutting Angle 30 °
Cutting Speed 110 mm/s
Fig. 5-65: Recipe for the product 'clamp'
Variable Value Unit
Material X20Cr13
Feedrate 20,00 mm/s
Setpoint Value Axis 1 45,6 mm
Setpoint Value Axis 2 51,20 mm
Cutting Angle 45 °
Cutting Speed 76 mm/s
Fig. 5-66: Recipe for the product 'shaft'