Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-169
Standard Mode
To print the message memory in part, the messages to be printed must
be selected in the message mask. This is done by pressing the Data
Release key in the message mask (or a corresponding button) and
selecting the messages in the message field using the Cursor Up and
Cursor Down keys.
The print job is started by pressing a soft key (or button) linked to the
system variable BlockPrint (prints visible part of the selected block) or
BlockPrintLong (prints messages of the selected block in full length).
The system variables can additionally be included in a configuration
mask and be edited online.
5.22.5.6 Direct Call of the Message Mask
In the programming software, you can link a function key or button with
a message mask. You can use this function key (the button must be
available in each mask) to go from each mask to the message mask.
As well as accessing the message mask from a selection menu, you
can then also use the function key to access the message mask. The
integrated LED of the function key then takes on the task of indicating
when new messages have been received. In this case, the LED flashes
when a new message has been received.
When you select the flashing function key, the system goes directly to
the message mask. When you select the function key again, the sys-
tem automatically returns to the previous mask. The usual flashing help
key LED is not available when programming a function key.
5.22.5.7 Message Output Formats
The following information is available for each external message:
• Message Number
•Date
•Time
• Message text
• The values of up to two variables, from the time the message ap-
pears (only if available)
You can use different system parameters to influence message display
in a message mask or on a printer. You can set these parameters
online in a programmed configuration mask.