Technical data

5-164 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
The Flash memory type used is being identified.
The voltage applied to the operating device is too high! This message
will not disappear until the specified supply voltage has been reached.
Initialization of the serial interface (unit 0 or unit 1) failed.
The program release of the SUCOnet K card and the current protocol
driver are not compatible. Retrofit the operating device or use the
appropriate driver version. The subcode specifies the level of the
SUCOnet K card.
The program level of the keyboard card and the current firmware are
not compatible. Retrofit the operating device. The subcode specifies
the level of the keyboard card.
Indicates a successful update operation. The operating device reboots
automatically.
A fatal error has been encountered. If this error message is displayed,
contact your local Bosch Rexroth service. Before calling, make a note
of the firmware and hardware version.
An unexpected interrupt has occurred. Contact your local Bosch
Rexroth service. Before calling, make a note of the interrupt number
(NR) and the program counter number (IP).
Is displayed after the device has been switched on or prior to a down-
load to indicate that the Flash Eprom cannot be erased.
Is displayed at the beginning of a download to indicate that the S3 file
is not the correct type for the operating device being used.
This message is displayed to indicate that no Flash supported by the
programming algorithm can be detected.
The application description stored in the FLASH contains errors. This
error may occur at the end of a transmission, e.g. if the transmission
was incomplete or after a device, with a defective memory, is switched
on.
An attempt has been made to load a S3 file which was intended for
another device type. When this error occurs, the correct type for this
operating device is displayed where "XXXX" appears. Recompile using
this selection in the programming system.
An attempt has been made to load a S3 file which was created for a
larger mask memory. The amount of memory space requested by the
S3 file and the memory available in the terminal do not match. When