Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-163
Standard Mode
must match.
The parameters of the interface SER1 (X2) were modified. To achieve
an operational connection, both communication partners must be set to
the new parameters. This message is used for informational purposes
if the connection to the communication partner cannot be established.
The operating system cannot find a protocol driver in the application
description loaded. Select a protocol, recompile the application
description and activate another download.
The protocol selected in the programming system when creating the
application description and the operating device's hardware are not
compatible. For example, the Interbus protocol driver has been loaded
to a device with standard interfaces.
A self-test is performed and the keyboard is checked when the operat-
ing device is switched on. Make sure no keys are pressed during this
process. Please follow the request. If this message is issued when no
key is pressed, it indicates that the keyboard is defective!
When the operating device is switched on, all messages in the operat-
ing device are sorted. This initialization process requires a certain
length of time based on the number of stored messages. The message
is always generated, but is only displayed for a very short time period
or is not visible at all.
Is displayed while the mask memory is being erased. All of the pro-
grammed data are erased at this point.
This message appears after the delete process is completed. Interface
SER2 (X3) is initialized for download operating mode.
The operating device indicates that it is ready for a download with a
baud rate of 19200 Bd via interface X3. A new project can now be
loaded or new interface parameters for the transfer can be exchanged.
The operating device indicates that it is ready for a download with the
new interface parameters. If no data are received within 20 s, the oper-
ating device will return to the DOWNLOAD 1 state.
The operating device will reboot after a few seconds.
The operating device reports its parameters during the startup process:
• CPU frequency in MHz
• Size of Flash memory in Kbytes
• Version number XXXXXXXX
• Loaded PLC driver YYYYYYYY