Technical data

5-158 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
5.22.2.8 System Message 8 - Invalid mask no
This text is displayed to indicate that a non-existing mask number has
been transmitted by the controller via the serial message channel.
5.22.2.9 System Message 9 - Invalid message no.
This text is displayed to indicate that the controller has transmitted a
message number that does not exist in the user interface.
5.22.2.10 System Message 10 - Print log invalid
The operator or the controller attempted to start a print log that does
not exist in the user interface.
5.22.2.11 System Message 11 - Interface in use
Interface X3 is already being used by another print job. You are
attempting to transmit different types of data to the printer at the same
time (e.g. to print recipes and messages).
5.22.2.12 System Message 12 - Invalid Password
You entered a password which does not exist in the password man-
agement function. With this message, the previous access authoriza-
tions (view and edit level) are reset.
5.22.2.13 System Message 13 - Password unchanged
The operator did not enter the same new password twice in a row.
5.22.2.14 System Message 14 - Overvoltage
The operating device has detected that the supply voltage is too high.
Switch the device off immediately to avoid damage. Check supply volt-
age.
5.22.2.15 System Message 15 - Data set protected
You attempted to modify individual values of a data set stored in the
Flash or to delete the entire data set.