Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-157
Standard Mode
If you delete the system message text from the user interface, no sys-
tem message will be issued, but the maximum permitted value will be
entered instead.
5.22.2.3 System Message 3 - Value too small
You are attempting to enter a value into a variable field of the editor
that is below the variable's lower limit. The lower limit is defined in the
user interface.
If you delete the system message text from the user interface, no sys-
tem message will be issued, but the minimum permitted value will be
entered instead.
5.22.2.4 System Message 4 - Replace battery
A test performed on the battery indicated that its capacity has fallen
below the limit value. This test is repeated every 60 minutes. To avoid
loss of data when replacing the battery, the information in the respec-
tive operating device's user manual must be complied with.
The same message appears when you remove the battery, switching
the device off at this point will, however, result in the battery-backed
data being lost!
5.22.2.5 System Message 5 - Message overflow
Indicates that the system is unable to process the external messages
quickly enough. Upon display of this message, one message has
already been lost.
5.22.2.6 System Message 6 - New message
This text is displayed when the operating device has received a new
external message whose priority exceeds the programmed threshold
value and no direct selector key has been assigned to the message
mask.
5.22.2.7 System Message 7 - Message buffer full
This text is displayed as a warning that the next external messages
may overwrite the oldest or lowest-priority messages (depending on
the configuration).