Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-153
Standard Mode
5.21.13 Print Logs
The general print log parameters include the printer setup (page set-
tings) and the variables defining the transfer of the print log number
from the controller to the operating device.
For the printer Page Settings you can specify the Lines in Page and
Characters in Line.
For detailed information on defining the page size, please refer to your
printer manual.
A variable must be defined to be able to transfer the print log number
from the controller to the operating device. If the controller transmits a
command to print a print log, the operating device uses the log number
currently stored in this variable.
To initialize the print log from the controller, the control code 7FF7h
must be written to the polling area.
The operating device writes the status of the print process to the same
controller address.
The following statuses are transferred:
Value Status
0 Printing complete
1 Printer in use
2 Print log not found
3 Print log stopped
Fig. 5-58: Parameters for print logs