Technical data

5-152 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
5.21.11 Parallel Outputs
You can define a cyclical variable for the parallel outputs allowing you
to control eight binary outputs via the operating device.
Specify the polling time for the repetition rate at which the variable is
read from the controller.
Choose the outputs you want to influence.
The cyclical variable addresses a word (2 bytes) in the controller. Two
bits of this word correspond to one output.
The following bit combinations apply:
5.21.12 Touch Parameters
You can define the following default settings for touch-sensitive operat-
ing devices:
• Default sound
• Duration of the sound
• Default image for system icon.
Default sound: This is the default setting for the signal tone that sounds when the but-
ton is pressed.
The following options are available:
• No sound
• Sound when pressed
• Sound when released
• Sound when pressed and released
• Continuous sound while pressed.
Duration of the sound: Enter a time in seconds.
Default image for system
icon:
Enter the default image here that is needed when system icons are
used.
Bit 1 Bit 2 Status of the LED
00OFF
0 1 OFF, FLASHING is preset
10ON
1 1 FLASHING
Fig. 5-57: Truth table for a parallel output