Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-151
Standard Mode
In the Default field, you enter an ASCII string that activates the scan-
ner.
In the Initialization field, you enter an ASCII string that configures the
scanner.
5.21.9 Gateway
Specifying gateway parameters is only relevant for operating devices
that are equipped with the necessary firmware.
You can specify the following parameters for these devices:
• Smallest possible slave number
• Largest possible slave number
• Polling time for text list
• Cache size
• Polling time for cache
• Variable for cache address
• Variable for network status address.
5.21.10 Data Set Transfer
The variables for the data set transfer are required when you intend to
use recipes in your project. These variables are used to handle the
data set transfer from the operating device to the controller.
A data set is clearly identified in the operating device by a unique rec-
ipe number and data set number.
The first two variables are used when the operator wants to transfer a
data set from the operating device to the controller. These variables
allow the controller to identify the data set being transferred. The trans-
fer is initiated by a bit in the Read coordination byte.
The two bottom variables allow the controller to request the transfer of
a data set from the operating device. For this process, the controller
writes the recipe number and the data set number of the respective
data set to the two variables and signals the request via a bit in the
Write coordination byte.
For more detailed information on initializing the scanner, please refer to
the documentation provided by the scanner manufacturer.
For current information on how to use a scanner, refer to the online help
of the programming software.