Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-145
Standard Mode
Select the Deactivate password function if mask change is initi-
ated by PLC check box if
• The mask change is to be initiated by the controller.
• A currently active password protection for the controller is to be de-
activated.
• You still want the operator to have to enter passwords to be able to
access the same mask.
Select the Enable mask change for active editor check box if you
want to allow the operator to change to another mask even when the
data release is active.
The Screen Saver area allows you to determine if
A. no screen saver is to be used
B. the screen saver is to be activated for masks without cyclical variables only
C. the screen saver is to be activated for masks with cyclical output variables
also
The turn-on time for the screen saver specifies the time interval
allowed to elapse after the last action before the display of the operat-
ing device is blanked. The LED in the help key will flash during this
time.
The Input Variables area allows you determine if
A. the input variable is to be displayed in inverse format while it is edited
B. pressing the Enter key lets you go to the next input variable
The Table Editor area allows you to determine if the cursor is to
advance to the next row or the next column when you press the Enter
key.
The Symbolic addresses for... area allows you to enter symbolic
addresses for the image of the mask number, the image of the DIP
switch (user mode switch), the Read coordination byte, the table index
and the image of the keyboard.
The screen saver is not available for use in all operating devices. There-
fore, while options for selection will be available, a delay time cannot al-
ways be entered.