Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-141
Standard Mode
5.19 Help System
For each mask and each input variable in the project, you can create a
help mask, and link these masks with each other. If you do not create
or link any help masks, the default help mask is displayed.
The help texts are always limited to the size of one single mask.
5.19.1 Default Help Mask
The default help mask is always displayed if you have not linked any
help mask to the mask or input variables. The default help mask is
always available and only displays a blank page if it is not pro-
grammed.
5.19.2 Help Mask for Masks
You can create a separate help mask for each mask.
You can link the help mask with the mask using the mask parameters.
If the operator is in a mask and data release has not been requested,
the help mask appears for this mask for the length of time you select
the Help key, or after he has chosen a button that has been pro-
grammed accordingly.
In order for the button to simulate the key function of the Help key, you
must create the Help key using the key simulation function, and link it
with the system variable KeyHelp.
5.19.3 Help Mask for Input Variable
You can create a separate help mask for each input variable.
You can link the help mask with the variable using the variable param-
eters.
If the operator is in a mask that contains a variable and data release
has been requested, the cursor must be located at the variable. In this
case, the help mask appears for the length of time he presses the Help
key, or presses the button that has been programmed accordingly.
The help mask for an input variable is specifically designed for specify-
ing the permitted range of values for the current input variable.
See chapter “KeyHelp“ on page 5-75.