Technical data

5-134 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
5.16.15 Send Keyboard Image to Controller
You can use the following control code from the controller, to have the
current keyboard status transferred from the operating device to the
controller.
Hexadecimal code: 7FFCh
5.16.16 Data Set Transfer from Controller to Operating Device (Single
Mode)
You can use the following control code from the controller, to have a
data set transferred from the controller to the operating device. The
data are read in single mode.
The number of the data set must be written to the variable defined for
this purpose.
In addition, the corresponding variables for the transfer buffers must be
defined.
Hexadecimal code: 7FFDh
5.16.17 Erase Serial Message Memory
You can use the following control code from the controller, to have the
entire message memory of the operating device's serial message sys-
tem erased.
Hexadecimal code: 7FFEh
5.16.18 Refresh Message System
You can use the following control code from the controller, to have the
operating device load all new parallel messages.
This allows implementation of an event-controlled message system.
Hexadecimal code: 7FFFh