Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-133
Standard Mode
5.16.12 Set Clock in Operating Device
You can use the following control code from the controller, to have the
operating device set the real time clock in the device as specified in a
defined control word.
For the clock, the year can be set as two digits only.
Hexadecimal code: 7FF9h
5.16.13 Data Set Transfer from Controller to Operating Device (Block
Mode)
You can use the following control code from the controller, to have a
data set transferred from the controller to the operating device. The
data are transferred in block mode.
The number of the data set must be written to the variable defined for
this purpose.
In addition, the corresponding variables for the transfer buffers must be
defined.
Hexadecimal code: 7FFAh
5.16.14 Data Set Transfer from Operating Device to Controller
You can use the following control code from the controller, to have the
operating device transfer a data set from the operating device to the
controller.
The number of the data set must be written to the variable defined for
this purpose.
In addition, the corresponding variables for the transfer buffers must be
defined.
Hexadecimal code: 7FFBh
See chapter “Date and Time Image“ on page 5-139.