Installation guide

20
4 / CARING FOR AND CLEANING YOUR APPLIANCEEN
• CHANGING AND CLEANING THE ANTI-GREASE FILTERS
• CHANGING THE LIGHT BULB
• INSTALL THE T-SHARP OUTELT
— Removing the  lters as the instruction in Pic. 12
— You can clean the  lter as below measure:
1. Soak them for about 3 minute in hot water
(40-50 degrees) with a grease-loosening
detergent then brush it gently with a soft brush.
Please do not apply too much pressure, avoid
damaging it.
2. It can be put into a dishwasher with
detergent, set the temperature at around 60
degrees.
— Please do not use abrasive detergent for it will
damage the hood;
— Make sure that the hood is shut off before
cleaning;
— Installing the carbon  lter:
1. Remove the Al  lter, see Pic.12
2. Insert the carbon  lter in the rectangular
hole,  tting it over the motor.
3. After inserting the front edge of the carbon
 lter into the slot on the cooker hood. Lower
the back edge of the carbon  lter, until it
clicks into place at the rear of the rectangular
hole. Raise the two  xing bars, until they are
horizontal over the carbon  lter. See Pic 13
4. Place the Al.  lter back to position.
5. Apply reverse procedure to uninstall the
carbon  lter.
Take the bracket and glass off and then take
the broken light bulb off, See Pic 14.
Fix the new light bulb,glass and bracket on.
— Fix the outlet outlet on the T-sharp, see
Pic 15.
— Fix the T-sharp outlet on the inside
chimney, see Pic 16.
Warning
the charcoal cannot be washed or re-
cycled. It should be changed at least every
four months.
Attention
Before changing the lights, ensure
that the appliance is not live.
Pic 14
Pic 16Pic 15
Pic 12
Pic 13