Operation Manual

English | 25
Bosch Power Tools 2 609 007 771 | (28.2.14)
After-sales Service and Application Service
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the fine-spray system.
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Bosch’s application service team will gladly answer questions
concerning our products and their accessories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
At www.bosch-pt.co.uk you can order spare parts or arrange
the collection of a product in need of servicing or repair.
Tel. Service: [phone]
E-Mail: [e-mail]
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: [phone]
Fax: [phone]
Australia, New Zealand and Pacific Islands
Robert Bosch Australia Pty. Ltd.
Power Tools
Locked Bag 66
Clayton South VIC 3169
Customer Contact Center
Inside Australia:
Phone: [phone]
Fax: [phone]
Inside New Zealand:
Phone: [phone]
Fax: [phone]
Outside AU and NZ:
Phone: [phone]
www.bosch.com.au
Republic of South Africa
Customer service
Hotline: [phone]
Gauteng – BSC Service Centre
35 Roper Street, New Centre
Johannesburg
Tel.: [phone]
Fax: [phone]
E-Mail: [e-mail]
KZN – BSC Service Centre
Unit E, Almar Centre
143 Crompton Street
Pinetown
Tel.: [phone]
Fax: [phone]
E-Mail: [e-mail]
No spray material emerges from
the nozzle
Sliding switch 24 is in position  Set the sliding switch 24 to “wood” or “wall”
application
No pressure build-up in container 7 Turn the container 7 towards the close
symbol until you hear the lock ring 6 en-
gage
Suction tube 15 loose Insert suction tube properly
Nozzle needle 13 clogged Clean nozzle needle
Suction tube 15 clogged Clean suction tube
Ventilation hole 16 on suction tube 15
clogged
Clean the suction tube and the ventilation
hole
Container seal 14 missing or damaged Slide a (new) container seal over the suction
tube into the groove
Spray material too viscous Dilute the spray material again and carry out
a test-spray run
Spray material dirty (lumps of paint) Completely empty and clean the spray gun;
pour the spray material through the filling
sieve when filling
Problem Cause Corrective Measure
OBJ_BUCH-2024-002.book Page 25 Friday, February 28, 2014 9:28 AM