Specifications

English | 19
Bosch Power Tools 1 619 929 K18 | (18.11.11)
After-sales Service and Customer Assistance
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Our customer service representatives can answer your ques-
tions concerning possible applications and adjustment of
products and accessories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: [phone]
Fax: [phone]
E-Mail: [e-mail]
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: [phone]
Fax: [phone]
Australia, New Zealand and Pacific Islands
Robert Bosch Australia Pty. Ltd.
Power Tools
Locked Bag 66
Clayton South VIC 3169
Customer Contact Center
Inside Australia:
Phone: [phone]
Fax: [phone]
Inside New Zealand:
Phone: [phone]
Fax: [phone]
Outside AU and NZ:
Phone: [phone]
www.bosch.com.au
Atomisation too course
Spraying capacity too high Turn thumbwheel 7 in direction I
Air flow too low Turn control knob 24 toward the right
Nozzle needle 16 soiled Clean nozzle needle
Too little pressure build-up in container 10 Screw container firmly against spray gun
Spray material too viscous Dilute the spray material again and carry out
a test-spray run
Air filter 29 heavily soiled Change the air filter
Spray jet pulsates
Not enough spray material in container Refill spray material
Venting hole on suction tube 12 clogged Clean suction tube and hole
Air filter 29 heavily soiled Change the air filter
Spray material too viscous Dilute the spray material again and carry out
a test-spray run
Nozzle seal 17 missing or incorrectly
mounted
Mount nozzle seal into spray gun (groove
must face away from the spray gun)
Spray material drips from the
nozzle
Deposits of spray material on nozzle needle
16 and air cap 3
Clean nozzle needle and air cap
Nozzle needle 16 worn Replace nozzle needle
Nozzle loose Tighten union nut 5
No spray material emerges from
the nozzle
Control knob for air flow 24 not set to “maxi-
mum air flow”
Set control knob for air flow 24 to “maximum
air flow”
No pressure build-up in container 10 Screw container firmly against spray gun
Suction tube 12 loose Insert suction tube properly
Nozzle needle 16 clogged Clean nozzle needle
Suction tube 12 clogged Clean suction tube
Venting hole on suction tube 12 clogged Clean suction tube and hole
Container seal 13 missing or damaged Slide (new) container seal over suction tube
Spray material too viscous Dilute the spray material again and carry out
a test-spray run
Problem Cause Corrective Measure
OBJ_BUCH-1543-001.book Page 19 Friday, November 18, 2011 9:16 AM