This cooktop is for use with Natural Gas and Universal LPG PCR915B90A Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München Cod. 9000198453 D www.bosch-home.
Dear customer, We would like to thank and congratulate you for your choice. This practical modern appliance has been made using materials of the highest quality, which have been put through the strictest of Quality Controls during manufacture and meticulously tested to ensure that they meet all of your cooking demands. We kindly ask you to read and follow these simple instructions in order to guarantee first-class results from the very start.
CONTENT Wiring diagram A Safety considerations For your safety What to do if yo smell gas Warnings Installation Preparing to install Clearances Installation of cooktop into Kitchen bench Installation procedure Connection Electrical connection Gas connection Conversion front Nat.
Service Trouble shooting chart What´s wrong ...If none of the electrical systems work? It is not always necessary to call the Service Centre. In some cases, you may be able to solve the problem yourself. This table contains some useful information. Important: Only authorised personnel from the Service Centre are qualified to work on the main gas and electric systems. Possible cause • Power turned off. • Faulty fuse. • The automatic circuit breaker or mains differential has been triggered. ...
11.The surfaces on heating and cooking appliances get hot when in use. Be careful. Keep children away from the appliance. 12.Only use your appliance for the preparation of food and never for room-heating purposes. 13.This appliance leaves the factory set for the gas supply indicated on the data label. Call the Service Centre if it needs to be altered. 14. Do not tamper inside the appliance. If necessary, call your local Service Centre. 15. Overheated fat or oil can easily catch fire.
Do not use small receptacles on large burners. The flame should not touch the sides of receptacles. Always use suitably sized receptacles on each burner. This helps avoid excessive gas consumption and prevents receptacles from getting tarnished. Do not cook without lids or with lids only partially covering receptacles. You are wasting energy. Always use lids. Only use thick-,flat-based saucepans, frying pans Do not use receptacles with and casseroles. uneven bases.
Clearances Installation of cooktop into the kitchen bench 7 A range hood fitted above the top must be installed according to the installation instructions for the range hood. A minimum distance of 650 mm is required for a range hood and 750 mm for an exhaust fan. Any adjoining wall surface situated within 200mm from the edge of any hob burner must be a suitable non-combustible material for a height of 150mm for the entire length of the hob.
User Instructions Boiling burners Use “High flame” setting to bring the pan to the boil, then adjust the flame between “High flame” and “Low flame” to maintain the required pan temperature. Important: The use of a cooktop leads to the production of heat and moisture in the kitchen .For this reason make sure that the room is properly ventilated.Keep natural ventilation openings, such as windows, open or provide a mechanical ventilation device(e.g. a range hood or overhead exhaust fan).
Installation continued Connection Electrical: An electrical 10 amp socket needs to be within 1 m of the hotplate to allow electrical connection. The socket must remain accessible after installation of the appliance. Important note: This appliance is connected to the mains (240 VAC) by means of the connecting lead which must be fixed to the kitchen unit to prevent it from coming into contact with hot parts of the hob (or an oven installed underneath) and remain accessible after installation of the cooktop.
Operating instructions Burner locations 7 11 4 1 5 2 6 1. Medium burner 2. Medium burner 3. Small burner Burner ignition & control 4. Rapid burner 5. Control Knobs 6. Big wok burner Depress control knob and turn anti-clockwise to “High flame”position. Hold the knob down for a few seconds until the flame ignites. Keep control knob depressed for a few seconds to activate the flame failure device. If ignition fails, depress knob again and wait for ignition.
Coverting the cooktop To change injectors All work involved in installation, setting and adaptation from Nat.Gas to to a different gas type must be carried out by authorised Universal LPG personnel from our Service Centre and must comply with current regulations and the conditions laid down by the local gas company. Request change-over injectors from our customer service deparment (refer injector chart below for sizes).
