User manual

NurseCall Main Unit Appendix | en 79
TeleAlarm SA® User Manual 953.92 | v1.0 | 2007.07
Change Day / Night
If you have activated the change Day / Night, the NurseCall system transfers all Alarms during
Night to the group 24. At Day, all groups 00 - 24 can be used. When switching from Day to Night
or vice versa, the Message "DAY-NIGHT" is transmitted to the activated pagers to signalize the
change.
Priority Alarms
The Assistance and Fire Alarms are priority calls transmitted to all activated pagers.
Call repetition
If Alarms/Messages are not acknowledged after about 7 minutes, call repetitions are also sent
to the group 23.
13.5.2 Multitone RPE670 with MEP protocol
Only Alarms/Messages arriving to the Alarm Buffer are transmitted (except "RELAY OFF"). The
transmission is only numeric. The Alarms/Messages are repeated every 1 or 3 minutes until
Acknowledgement (see Section 7.4.13 RS232 message setting (toggle), page 55).
The Alarms/Messages are transmitted to the Multitone user number attributed to the
Transmitter (default group = 00).
22 34GG
23 35GG
24 36GG
Group User number
Table 13.5 Attribution table
i
NOTICE!
In "floor / room / bed" Display Mode, use only alpha-numeric pagers which can store more than
16 characters.
i
NOTICE!
Data rate: 1200 Bauds. Transmission: asynchronous with a 10 bit-structure
(1 startbit, 7 databits with even parity, 1 stopbit) in half-duplex mode.
Group User number
00 12GG
01 13GG
02 14GG
03 15GG
04 16GG
05 17GG
Table 13.6 Attribution table