Manualshelf

User manual

ManualsBrandsBosch ManualsConsumer electronicsNurseCall Main Unit
61626364656667686970
NurseCall Main Unit Operating Instructions | en 63
TeleAlarm SA® User Manual 953.92 | v1.0 | 2007.07
8.2.2 Display indications
Following information is displayed at Alarm/Message arriving:
First information block
– In case of "floor / room / bed" Display Mode:
1. Criterion of the Alarm/Message;
2. Alarm (A) - or Event (E);
3. Identification of the Transmitter location;
(floor/room/bed number).
– In case of "single number" Display Mode:
1. Criterion of the Alarm/Message;
2. Alarm (A) - or Event (E);
3. Identification of the Transmitter location;
(single number).
Second information block
–In both Display Modes:
4. Date of the Event;
5. Time of the Event;
6. Main Unit (space) or Relay Unit (A...f)
identification number;
7. Quality of the received radio signal.
Third information block
–In both Display Modes:
8. Position of the last passed beacon.
In the Alarm Buffer, the total number of entries is
indicated on top at the right. You can immediately
see how many Alarms are active (in our example,
there are totally 3 Alarms in the Alarm Buffer.
On the other hand, in the Event Buffer the position
of the Event in the Buffer is indicated
(E01 corresponds to the latest entry in the Event
Buffer).
i
NOTICE!
With the Yellow button, you can switch between three available information blocks.