Manualshelf

User manual

ManualsBrandsBosch ManualsConsumer electronicsNurseCall Main Unit
41424344454647484950
NurseCall Main Unit Programming | en 47
TeleAlarm SA® User Manual 953.92 | v1.0 | 2007.07
Example of programming
Paging or DECT phone system (RPE 670 system = YES, Day / Night transfer function = YES,
ESPA 4.4.4 protocol, Localization Mode = ON and Display Mode = NUMBER).
X For more information about such systems, see Section 13.5.1 Multitone RPE670 with ESPA
4.4.4. protocol, page 78 and Section 13.6.1 Multitone DECT system CS600 and P318
interface, page 85.
1. If you have selected PAGING, you should
select if you wish to use the RPE 670 system
(YES) or others (NO) with the
and
keys.
X By using the DeTeWe protocol, you should
answer this question. Nevertheless, the
system ignores your response.
2. Confirm your selection with
.
3. Thereafter, or if you have selected DECT, you
should decide if you wish to activate the Day
/ Night transfer function (YES) or not (NO)
with the
and keys.
4. Confirm your selection with .
X If you have activated the Day / Night transfer
function, the NurseCall system transfers all
Alarms during Night to the group 24. At Day,
all groups 00 - 24 can be used. At the
moment of the switching from Day to Night
or vice versa, the message "DAY-NIGHT" is
transmitted to the activated pagers (DECT
phones), in order to signalize the change. In
this case, you should program the Night
starting time (default time = 18h00) and the
Night end time (default time = 06h00).
5. Set the Night starting time and confirm your
setting with
.
6. Set the Night end time and confirm your set-
ting with
.
X Use the
and keys for field selection
and the and keys for value
changing.