User manual

44 en | Programming NurseCall Main Unit
953.92 | v1.0 | 2007.07 User Manual TeleAlarm SA®
7.3.2 Access to parameters
1. Press  then to access the parameters.
2. Press  to program these parameters or
 to check the value of each parameter.
3. Select the parameter you wish to change/
check by scrolling with
 or .
7.3.3 List of parameters
s
X OK:Program
¤:Info
X Parameter Nr. 00
Language £
No. Parameter Reference
00 Language Section 7.3.4 Programming the interface language, page 45
01 Date and Time Section 7.3.5 Date and time setting, page 45
02 RS-232 Output Section 7.3.6 RS-232 output setting, page 46
03 Local Ack. Section 7.3.7 Local Acknowledgement setting, page 50
04 Relay Output Section 7.3.8 Output relay setting, page 50
Table 7.2 Programming references