User manual

4 en | NurseCall Main Unit
953.92 | v1.0 | 2007.07 User Manual TeleAlarm SA®
6 Installation 27
6.1 Unpacking 27
6.1.1 List of contents 27
6.2 Installation 28
6.2.1 Generalities 28
6.2.2 Installation on a piece of furniture 28
6.2.3 Wall installation 28
6.2.4 Installing the antenna 29
6.2.5 Connecting to the mains 30
6.2.6 Connecting the RS-232 31
6.2.7 Setting the jumpers on RS-232 board 32
6.2.8 Connecting the RS-485 33
6.2.9 Setting the 100 Ohm termination jumper 34
7 Programming 35
7.1 Generalities 35
7.1.1 Programming with keyboard 35
7.1.2 Programming with NPS software 36
7.1.3 Exiting the programming mode and cancelling entries 36
7.1.4 Key not allowed 36
7.2 First use 37
7.2.1 List of original factory settings 37
7.2.2 Language 38
7.2.3 Localization Mode 38
7.2.4 Display Mode 38
7.3 Parameters 39
7.3.1 Diagrams 39
7.3.2 Access to parameters 44
7.3.3 List of parameters 44
7.3.4 Programming the interface language 45
7.3.5 Date and time setting 45
7.3.6 RS-232 output setting 46
7.3.7 Local Acknowledgement setting 50
7.3.8 Output relay setting 50
7.4 Special settings 51
7.4.1 Displaying firmware version 51
7.4.2 Resetting all parameters (including date and time) 51
7.4.3 Assistance and fire priority 52
7.4.4 Assistance and fire non priority 52
7.4.5 Special texts in German 52
7.4.6 Standard texts in German 52
7.4.7 Standard NurseCall selection 53
7.4.8 Universal NurseCall selection 53
7.4.9 Maximum number of Alarm Transmitters (toggle) 54
7.4.10 Maximum number of Acknowledgement Transmitters (toggle) 55
7.4.11 Maximum number of Events buffered (toggle) 55
7.4.12 Daily message setting (toggle) 55
7.4.13 RS232 message setting (toggle) 55