User manual

NurseCall Main Unit Installation | en 31
TeleAlarm SA® User Manual 953.92 | v1.0 | 2007.07
6.2.6 Connecting the RS-232
X Connect the intended device by the 9-pole SUB-D connector (1) at the rear part of the
housing.
X For connector wiring, see Section 13.7.3 RS-232 (unit rear), page 87.
Fig. 6.4 Rear view
1. Disassemble the unit as described in Section 10.5.2 Unit Dismantling, page 68.
2. Remove the RS-232 board as described in Section RS-232 board removing, page 69.
3. Set the jumpers as required in your configuration.
X See Section 6.2.7 Setting the jumpers on RS-232 board, page 32
4. Assemble the RS-232 board and the unit. This is basically the reverse of the dismantling
procedure.
1
i
NOTICE!
Inside the NurseCall Main Unit, the RS-232 interface should be configured with jumpers.