User manual

NurseCall Main Unit Description | en 19
TeleAlarm SA® User Manual 953.92 | v1.0 | 2007.07
Keys Programming Mode Normal Operation
+
Access to Parameters programming
X See Section 7.3 Parameters, page 39
Not currently used
+
Access to Transmitters programming
X See Section 7.5 Transmitters, page 56
Not currently used

To scroll up to the next parameter To increase the volume of the
loudspeaker
X See Section 8.1 Loudspeaker
volume adjusting, page 61

To scroll down to the next parameter To decrease the volume of the
loudspeaker
X See Section 8.1 Loudspeaker
volume adjusting, page 61

To set a parameter value to OFF or to go to
the previous programming field
(example date: MM.DD.YY)
To scroll down to the previous
Alarm/Event

To set a parameter value to ON or to go to
the next programming field
(example date: MM.DD.YY)
To scroll up to the next
Alarm/Event

To confirm a value or a command Not currently used

To cancel an entry or a command.
To quit the programming mode
Not currently used

To check the value of a Parameter or a
Transmitter
To check the status of the backup
battery
X See Section 10.3 Backup bat-
tery monitoring and checking,
page 67

Not currently used Not currently used
+ 
NPS programming function
X See Section 7.1.2 Programming with NPS
software, page 36
Not currently used
 to 
To enter a value Not currently used

To erase all programmed Acknowledgement
Transmitters during a specific procedure
X See Section 7.5.8 Erasing all Acknowl-
edgement Transmitters, page 60
Not currently used

Not currently used Not currently used

To enter a value To launch the Event/Alarm display
mode
Table 4.3 Keys functions