Installation Guide

6
Prepare Installation Space
Create the cut-out in the countertop according to the
installation diagram. The angle of the cut surface to the
countertop must be 90°.
The lateral cut-out edges must be flat in order to ensure
that the retaining springs are positioned properly on the
appliance. With multi-layered countertops, secure strips
laterally in the cut-out if necessary.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat- and water-resistant manner.
Observe minimum distance between device underside
and furniture parts of
3
/
8
" (10 mm).
The worktop into which the cooktop is installed must be
heat-resistant up to 140° F (90 °C).
The worktop must be reinforced if it is less than
4
/
5
inch
(20 mm) thick.
If the thickness of the worktop into which the cooktop is
installed does not comply with the specifications,
reinforce the worktop using a fire- and water-resistant
material until it reaches the minimum thickness.
Otherwise, sufficient stability cannot be guaranteed.
▯ The worktop into which the cooktop is installed should
withstand loads of approx. 133 lbs (60 kg).
▯ Only check the evenness of the hob after it has been
installed.
Cutout dimensions for 30" cooktops
Models: NIT5068UC, NIT8068SUC, NIT8068UC,
NITP068SUC, NITP068UC
Cutout dimensions for 36" cooktops
Models: NIT5668UC, NIT8668SUC, NIT8668UC,
NITP668SUC, NITP668UC
PLQPP

PP

PP
PLQPP

[
¡
PP
PLQPP
PLQ
PP
PLQ
PP
PLQPP
PLQPP

PP

PP

[
¡
PP
PLQPP
PLQ
PP
PLQ
PP