Installation manual

Installation material and tools
This section describes installation material such as cables, connectors and tools.
Recommedations
– Always use manufacturer specified installation products, materials and tools.
– In general, use different cable ducts for the system network cables, audio cables and
mains supply cables.
– In public areas where people can touch or move above the connectors and cables, use
metal protection covers.
!
Warning!
Do not exceed the bend limitations of system network cables (DCNM‑CBxxx):
The minimum bend radius of the system network cable is 50 mm radius.
DCNM-CBxx System Network Cable
The system network cables, terminated with connectors on both ends, are available in
different lengths and are used to connect DCN multimedia devices to each other. The cable
consists of four CAT‑5e twisted pairs to transmit data and two copper wires to supply the
power.
Ordering number Cable lengths
m ft
DCNM-CB02 2 6.56
DCNM-CB05 5 16.40
DCNM-CB10 10 32.81
DCNM-CB25 25 82.02
Table 5.1: Cable types and lenghts
Figure 5.1: DCNM-CBxx cable and connector view
5
5.1
16 en | Installation material and tools DCN multimedia
2013-08 | V1.0 | Hardware Installation Manual Bosch Security Systems B.V.