NES 730 UC NES 930 UC Bosch Ceramic Glass Cooktops Models: NES 730 UC, NES 930 UC
mnstaHation Instructions HodeHs: NES 730, NES 930 Table of Contents NOTE: Pages The blocked 2 & 4. klatch Overall letters, these junction Box Location and Clearances Cutout Cooktop Electrical 2, 3 D ............................................................................................. 2 Dimensions E .......................................................................... Countertop OWNER: Please Installations retain these H and | .............................................
mnstammationmnstructions Hodeb: OveraJJ Dimensions Mode[ NES 730:Width 30" Mode[ NES 930:Width 36" All Cabinet Power SuppJy Mode[ NES 730:30 Amp circuit breaker Mode[ NES 930:40 Amp circuit breaker All Models: Depth 2 [ - [/8" Height above countertop: Minimum Cabinet Required NES 730_ NES 930 240 Volt, 4 Wire, 208 Volt, 4 Wire, 1/4" Junction Clearances Box 60 Hz 60 Hz Location Bottom Wall EEl Building Back Wall II/'"i4 Zox Cooking Sut face Counter Top Cutout Dimensions
installation Instructions HodeHs: NES 730, NES 930 CABINET PREPARATION CLEARANCES COUNTERTOP DiMENSiONS AND C The cutout CUTOUT dimensions depend upon To eliminate the risk of burns or fire by reaching installation is for over heated surface units, cabinet storage space located above the surface units should be installation in a solid surface countertop avoided, ff cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of
mnstammationmnstructions Foam Hodels: NES 730_ NES 930 Tape Seam Solid Surface Countertop mnstaHation Location of aluminum reflectivetape Installing Over An Oven 27}/8" / L: Coo!{top ConduitJ I L .
mnstaHation Solid Instructions Surface HodeHs: NES 730, NES 930 ELECTRICAL Countertops Always consult manufacturer the for countertop specific Round 2.
mnstammationmnstructions HodeHs: NES 730_ NES 930 BEFORE CALLING If the elements power source do not See Use and Care data The data the center Keep your heat or if the indicator to see if a fuse has blown Refer to the Cooktop Product FOR SERVICE plate Vgarranty manual "on" or if the light circuit does breaker not gJow, check the has tripped. on Page 12 of the Use and Care Hanual. for troubleshooting information.
Specifications are for pHanning purposes onHy. Refer to instaHHation instructions counter opening. ConsuHt with a heating and ventiHating engineer information, refer to InstaHHation Instructions accompanying product _A/e reserve the right to change specifications responsibHe for products which are transported or deaHer. For the most Note:The referred to throughout countertop suppHier prior or design without notice. Some modeHs are certified for use in Canada.
