Operation Manual

IVA 4.0 Configuration | en 11
Bosch Security Systems Operating Manual DOC | 4.0 | 2009.06
3 Configuration
IVA 4.0 and IVA 4.0 Flow are set up using the Configuration Manager program or via the Web
browser view of the device.
You must move the camera to the required position first in each case. When using
VG4 AutoDome, the individual presets must be specified before configuring IVA 4.0 for each
preset.
All of the settings you make relate to the selected camera position. This means that you must
reconfigure IVA 4.0 for this camera whenever you change the camera's direction or position.
For more details, also refer to: Section 6 IVA and VG4 AutoDome, page 58.
3.1 Configuration with Configuration Manager
Configuration Manager can be installed on any Windows PC.
The system requirements and operation of Configuration Manager are described in the
Configuration Manager Installation and Operating Manual. You can access the online Help for
Configuration Manager by selecting Help > Online Help... when you are in Configuration
Manager.
1. Start Configuration Manager.
2. Make sure the File > Advanced Mode option is active.
3. From the Devices main tab, select the device for which you would like to configure
IVA 4.0
or
from the Cameras main tab, select the camera for which you would like to configure
IVA 4.0.
4. In the display area, click the VCA tab to switch to Video Content Analysis.
The camera image appears on the right. You see an individual image that is refreshed at
regular intervals.
5. Under VCA configuration, select either Profile 1 or Profile 2.
If necessary, change the name of a profile by clicking .
There are ten profiles available for VG4 AutoDome. Each profile can be used for one
preset.
6. VG4 AutoDome only: Select an entry from the list under Domescene.
The camera positions for individual presets must be defined in advance. These presets
may already be named individually.
Only presets that are not yet linked to one of the profiles are available.