Operation Manual

12 en | Configuration IVA 4.0
DOC | 4.0 | 2009.06 Operating Manual Bosch Security Systems
7. Select IVA 4.0 or IVA 4.0 Flow as the Analysis type.
If you change the analysis type, the motion detection and tamper detection parameters
revert to the default settings.
As soon as the analysis becomes active, meta data is generated and, depending on the
configuration, additional information is overlaid on top of the camera image — an object
bounding box for example.
8. Click Configuration....
The IVA Wizard window opens. IVA 4.0 and IVA 4.0 Flow are configured via this window.
Please see the following for details on the configuration options:
– Section 4 IVA 4.0, page 14
– Section 5 IVA 4.0 Flow, page 49
If the IVA Wizard is already in use by another user, you will receive a message to that effect.
The configuration window cannot be opened again at the same time.
Alarm status
This field shows whether IVA 4.0 has generated an alarm event with the current settings.
3.2 Configuration Using Web Browser
You can also configure IVA 4.0 using the Web browser view of the device.
1. Open the Web browser view of the device.
2. Select SETTINGS > Advanced Mode > Alarm > VCA to switch to Video Content Analysis.
The camera image appears on the right.
3. Under VCA configuration, select either Profile 1 or Profile 2.
If necessary, change the name of a profile by clicking .
There are ten profiles available for VG4 AutoDome. Each profile can be used for one
preset.
4. VG4 AutoDome only: Select an entry from the list under Domescene.
The camera positions for individual presets must be defined in advance. These presets
may already be named individually.
Only presets that are not yet linked to one of the profiles are available.
5. Select IVA 4.0 or IVA 4.0 Flow as the Analysis type.
If you change the analysis type, the motion detection and tamper detection parameters
revert to the default settings.
As soon as the analysis becomes active, meta data is generated and, depending on the
configuration, additional information is overlaid on top of the camera image — an object
bounding box for example.
6. Click Configuration....
The Settings window opens. IVA 4.0 and IVA 4.0 Flow are configured via this window.
Please see the following for details on the configuration options:
– Section 4 IVA 4.0, page 14
– Section 5 IVA 4.0 Flow, page 49
If the IVA Wizard is already in use by another user, you will receive a message to that effect.
The configuration window cannot be opened again at the same time.