Mounting Poles MP1/MP2/MP3 en Installation Guide
Mounting Poles 1 Installation Guide | en 3 Installation Guide For mounting Bosch Security Systems’ photoelectric beam detectors, use the MP1, MP2 straight metal poles, or MP3 curved metal pole. These poles are manufactured from steel and pre-finished with a dark, gloss, acrylic paint to resist rust. Refer to the following figure for height and diameter information. 1 2 1.2 m x 45 mm Ø (4 ft x 1.75 in. Ø) 3 0.9 m x 45 mm Ø (3 ft x 1.75 in. Ø) 0.3 m x 45 mm Ø (1 ft x 1.75 in. Ø) 18 mm (0.5 in.
en | Installation Guide Mounting Poles You can anchor the MP1 and MP2 poles to floors with bolts using the four 14 mm (9/16 in.) flange holes shown in the following figure. You can mount the poles outdoors on a suitable concrete base. 9 (3 0 m .5 m in .) 1 Figure 1.2: Flange bottom view Callout — Description 1 — 14 mm (9/16 in.) holes (4) Wall mount the MP3 using the four 14 mm (9/16 in.) flange holes. Notice! No hardware is supplied with the MP1, MP2, and MP3 poles.
Mounting Poles Installation Guide | en – 5 Firmly anchor the poles to resist movement and vibrations. This is especially important when mounted outdoors where poles can be subject to high winds. – Install poles within the detector’s maximum range. – Install the poles so the path between the transmitters and receivers is clear and will remain clear of obstructions. If installed outdoors, do not allow trees, weeds, and plants to grow into the path between the transmitters and receivers.
Bosch Security Systems, Inc. 130 Perinton Parkway Fairport, NY 14450 USA www.boschsecurity.com © Bosch Security Systems, Inc., 2016 Bosch Sicherheitssysteme GmbH Robert-Bosch-Ring 5 85630 Grasbrunn Germany www.boschsecurity.
