Technical data
Set Baud 1200 N/A N/A N/A N/A 106
Set Baud 2400 N/A N/A N/A Learn
28
N/A
Set Baud 4800 N/A N/A N/A Learn
41
N/A
Set Baud 9600 N/A N/A N/A Learn
40
105
Show Startup
[Boot]Message
N/A N/A Learn
99
N/A N/A
Address Change Use
Cams
et;
Valid
Range
1-99
Bosch
AUX
14 &
21
Valid
Range
1- 126
Use
Cams
et
Valid
Range
1-254
See
notes.
Valid
Range
1-254
126 Pelco: Learn 60 Twice; then
Learn # for new address
Camera Command
Preset1 to Preset10
N/A N/A Go To
240-2
49
Go To
240-249
240-2
49
Camera Recalibrate Learn
50
N/A Learn
251
Learn
94
N/A
Inverted (Adjusts the
pan controls)
N/A N/A N/A Learn
80
N/A
Upright (Adjusts the
pan controls)
N/A N/A N/A Learn
81
N/A
Pelco D Patterns
To Record/playback a Pattern: (Save Presets prior to this!)
1. Select the TOUR number to be recorded using Learn # (50 to 55 for Pattern 1 to 6); (Pelco
requires entering the number, and then PRESS & HOLD the PRESET key for greater then 3
seconds. E.g. Pattern 6 would be 55, Press & Hold PRESET > 3 seconds.
2. START the Recording using Learn 48. (enter 48, Press & Hold PRESET).
3. Go to Preset #, wait the dwell time, go to next preset #, etc. (1 PRESET, 2 PRESET, etc.; this
time just press & release the Preset key).
NOTE: As a result, the MIC will move to Preset 1, stay there until the next preset command is
received (say 10 seconds), then move to the Next Preset.
4. STOP the Recording using Learn 49. (enter 49, Press & Hold PRESET).
5. Press the PATTERN key to playback that last activated/recorded tour.
Pelco D Change Address PRESET 60
To change the address of a camera, Learn preset 60 twice, then learn another preset. The
number of the preset will become the new address. For example, to set a camera to address
32, Learn presets 60,60,32 without moving the camera or sending any other data in between.
Inverted/Upright
For units mounted like a dome, the left and right is reversed. Set this by learning preset 80
INVERTED Learn Preset 80
UPRIGHT Learn Preset 81
MIC440 Explosion-protected Camera
Operation | en 51
Bosch Security Systems, Inc. Operation Manual 2013.11 | 8.1 |