Technical data

!
Warning!
These power supply units are NOT explosion-proof and must be installed outside of the
hazardous environment.
Additional Tools Required
The following table lists additional tools (not supplied by Bosch) that are or may be required
to install a MIC camera:
Quantity Part
1 13 mm wrench for the mounting bolts
1 3 mm screwdriver for the terminal blocks in the MIC PSU
1 8 mm screwdriver for captive screws for the MIC PSU enclosure
1 Silicone sealant for ensuring a water tight seal [if not using the Nebar gasket]
1 Roll of PTFE tape
3.3
14 en | Unpacking MIC440 Explosion-protected Camera
2013.11 | 8.1 | Operation Manual Bosch Security Systems, Inc.