Spec Sheet

to a flat masonry surface. The MIC-SPR is
manufactured from either aluminum plate or stainless
steel.
Supplied hardware includes:
• Four (4) M8 x 30 stainless steel cap head bolts
• Four (4) M8 stainless steel plain washers
• Four (4) M8 stainless steel nuts
Shallow Conduit Adapter
The MIC Shallow Conduit Adapter (MIC-SCA) is used
as required with other mounting brackets. The MIC-
SCA has a single M25 side entry conduit fitting hole.
There is not sufficient room inside to allow the camera
to be mounted to it directly. (Use a MIC-DCA instead.)
The MIC-SCA is machined from either aluminum or
stainless steel.
An O-ring seals the camera-to-mount interface to an
ingress rating of IP68.
Supplied hardware includes:
• Four (4) M8 x 20 stainless steel hex bolts
• Four (4) M8 stainless steel plain washers
• One (1)O-ring, 80 mm x 3 mm
• One (1) end cap/blanking plug, M25 x 1.5, with O-ring
Other Hardware Accessories
MIC-M25XNPT34 Thread Adapter
The MIC-M25XNPT34 conduit adapter (male M25 to
female 3/4" NPT) allows attachment of ¾” NPT
conduit that is popular in the North American region to
MIC-DCA and MIC-SCA mounts that have M25x1.5
threaded holes. This adapter is included with the
following DCA models: MIC-DCA-HBA, MIC-DCA-HWA,
and MIC-DCA-HGA. The adapter is manufactured from
316 stainless steel and includes a silicone O-ring that
seals the adapter to the DCA to an ingress rating of
IP68.
Sunshield Kits
Sunshield Kits are available for MIC440 cameras,
MIC412 or MIC612 cameras, and MIC7000 cameras.
Each kit is designed to provide additional protection
for the camera from direct solar radiation, particularly
in sunny climates, by reflecting solar exposure, and by
creating an insulating gap between the environment
and the surface of the camera.
Sunshield Kit for MIC7000 cameras
The Sunshield Kit for MIC7000 cameras
(MIC-67SUNSHLD) includes three (3) white, molded
parts: a bottom shell, one top shell for a camera
without an illuminator accessory, and one top shell for
a camera with an illuminator accessory.
Supplied hardware includes:
• Two (2) M4 x 14 stainless steel socket head Torx
screws
• Four (4) M4 x 8 stainless steel socket head Torx
screws
• Four (4) M4 stainless steel flat washers
Sunshield Kit for MIC612 and MIC412 cameras
The Sunshield Kit for MIC thermal cameras
(MICTHERSUNSHLD) includes two (2) white, molded
shells.
3
| MIC Mounting Brackets and Other Accessories