Spec Sheet

The hinge feature allows installers to “hang” the
MIC7000 camera temporarily during installation for
easier connection of cables/wiring before final bolts
are installed.
Although the hinge feature is only available when used
with a MIC7000 camera, this DCA is otherwise
compatible with MIC analog cameras also.
An O-ring seals the camera-to-mount interface to an
ingress rating of IP68.
Supplied hardware includes:
• Four (4) M8 x 20 stainless steel hex bolts
• Four (4) M8 stainless steel plain washers
• One (1)O-ring, 80 mm x 3 mm
• One (1) end cap/blanking plug, M25 x 1.5, with O-ring
• One (1) conduit adapter (male M25 to female 3/4"
NPT)
Wall Mount Bracket
The MIC Wall Mount Bracket (MIC-WMB) allows
mounting on building walls. It is also used with a MIC
Pole Mount Bracket (MIC-PMB) and a MIC Shallow
Conduit Adapter (MIC-SCA) to allow mounting on lamp
posts, scaffolding, and other nonstandard mounting
posts. The MIC-WMB is manufactured from either
aluminum or stainless steel. It has a deep bowl to
accommodate the signal cable connections.
An O-ring seals the camera-to-mount interface to an
ingress rating of IP68.
Supplied hardware includes:
• Four (4) M8 x 20 stainless steel hex bolts
• Four (4) M8 stainless steel plain washers
• One (1)O-ring, 80 mm x 3 mm
Pole Mount Bracket
The MIC Pole Mount Bracket (MIC-PMB) is designed to
work with a MIC Shallow Conduit Adapter (MIC-SCA)
and a MIC Wall Mount Bracket (MIC-WMB) to allow a
MIC camera to be mounted on a lamp post,
scaffolding, and other nonstandard mounting post
with a wide range of diameters. The MIC-PMB is
manufactured from clear anodized aluminum.
Supplied hardware includes:
• Four (4) M8 x 30 stainless steel cap head bolts
• Six (6) M6 x 20 stainless steel countersunk head
bolts
• Two (2) high-torque stainless steel worm drive clips
(banding straps), 1 m long
• Two (2) pole mount blocks
• One (1) mounting plate
Corner Mount Bracket
The MIC Corner Mount Bracket (MIC-CMB) is designed
to work with a MIC Shallow Conduit Adapter (MIC-
SCA) and a MIC Wall Mount Bracket (MIC-WMB) to
allow a MIC camera to be mounted on the corner of a
building. The MIC-CMB is manufactured from either
aluminum or stainless steel.
Supplied hardware includes:
• Four (4) M8 x 25 stainless steel hex bolts
• Four (4) M8 stainless steel plain washers
• Four (4) M8 stainless steel nuts
Spreader Plate
The MIC Spreader Plate (MIC-SPR) is used to spread
the weight of a MIC camera and its supporting
brackets so that the camera can be mounted securely
2
| MIC Mounting Brackets and Other Accessories