Operation Manual

Return to the LIVE page.
Click the Aux Control tab.
Type 8 in the input box and click the Aux On button.
5. To stop the tour, type 8 and click the Aux Off button.
Sectors
Sector
The camera’s pan capability is 360° and is divided into 16 equal sectors. This section allows
you to apply a title for each sector and to designate any sectors as a Blanked Sector.
To define a title for sectors:
1. Place the cursor in the input box to the right of the sector number.
2. Type a title for the sector, up to 20 characters long.
3. To blank the sector, click the check box to the right of the sector title.
No white light
Specifically for MIC cameras using the IR/White light illuminator:
Select this check box to prevent activation of the White light illuminator in the corresponding
sectors, such as those which include highways / roads where White light might create a
hazardous situation such as blinding a driver.
When this check box is selected, no White lights will activate for Presets stored in the
corresponding sector.
Miscellaneous
Fast address
This parameter allows the appropriate camera to be operated via the numerical address in the
control system. Enter a number between 0000 and 9999, inclusive, to identify the camera.
Audio
Note for MIC7000 cameras only: These options are available only if you have connected a
VIDEOJET connect device (NPD-PSU-HPOE) to your camera.
You can set the gain of the audio signals to suit your specific requirements. The current video
image is shown in the small window next to the slide controls to help you check the audio
source and improve assignments. Your changes are effective immediately.
If you connect via Web browser, you must activate the audio transmission on the LIVE
Functions page. (See LIVE Functions, page 50.) For other connections, the transmission
depends on the audio settings of the respective system.
Audio
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data are encoded according to G.711 and require an additional
bandwidth of approximately 80 kbps for each connection. If you do not want any audio data to
be transmitted, select Off.
Input volume
You can set the input volume with the slider (from 0 to 31, with 0 as the default).
Line In
You can set the line input gain with the slider (from 0 (zero) to 79, with 0 as the default).
Make sure that the display does not go beyond the green zone during modulation.
Line Out
You can set the line output gain with the slider (from 0 (zero) to 79, with 0 as the default).
Make sure that the display does not go beyond the green zone during modulation.
15.20
15.21
15.22
64 en | Configuration via IP, Advanced Mode
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
2014.05 | 1.0 | F.01U.291.520 Operation Manual Bosch Security Systems, Inc.