Technical information

ST-PU-0006-14
8
TrainingUpdate
Diagnose New Systems in the Interactive
Diagnostic Exercises
There are four new diagnostic exercises now avail-
able on the ACDelco Learning Management System.
These exercises are interactive courses that cover
specific procedures on a vehicle system.
Active Safety System and SRS Diagnostic
Exercise (S-ST10-01.01SIM) – Diagnose an intermit-
tent airbag warning lamp and an airbag warning lamp
that stays on, as well as service the Driver Assist
System.
Braking Systems Diagnostic Exercise (S-BK05-
02.01SIM) — Diagnose and resolve a wheel speed
sensor fault.
GM Chassis Control Systems Diagnostic Exercise
(S-SS04-02.01SIM) – Diagnose a fault in the multi
axis sensor, the suspension position sensor, and the
wiring for the multi axis sensor and steering wheel
angle sensor.
Tire Pressure Monitoring System Diagnostic
Exercise (S-SS04-01.01SIM) – Diagnose a defective
Remote Control Door Lock Receiver, a defective tire
pressure monitoring sensor, and an incorrect setup in
the BCM for the Tire Pressure Monitoring System.
To launch a diagnostic exercise, perform a catalog
search and select Simulation under Delivery Type.
Course Number Course Name
S-AC07-02.01ILT Automotive Air Conditioning Advanced Refrigerant
System Diagnostics
S-AC07-03.01ILT HVAC Control System Operation and Diagnostics
S-BK05-02.01ILT ABS Operation and Diagnosis
S-BK05-03.01ILT Electronic Brake and Chassis Controls: Is the
vehicle really smarter than the driver?
S-DS11-13.01ILT Vehicle Network Communications: When modules
talk, who is really listening?
S-EL06-04.02ILT Network Communication Diagnosis
S-EL06-10.02ILT Electrical Power Management
S-EL06-11.02ILT Enhanced Automotive Circuit Diagnosis
S-EL06-13.01ILT Body Electrical Global Diagnostics
S-EL06-14.01ILT Advanced Body Control System Electrical
Diagnostics
S-EL06-16.01ILT Hybrid Vehicle Service and Safety: Batteries
Included
S-EM01-01.01ILT Valvetrain Controls: Are they phasing you?
S-EP08-02.01ILT Engine Performance Computer Controls and
Ignition System Diagnostics
S-EP08-03.01ILT Engine Performance Air Induction and Fuel
System Diagnostics
S-EP08-04.01ILT Engine Performance Fault Monitoring and
Emission System Diagnostics
S-EP08-05.01ILT Engine Performance Advanced Drivability
Diagnostics
S-EP08-06.01ILT After Combustion Sensors: Is what is in the
exhaust making your engine run rough?
S-EP08-07.01ILT Air Induction and Fuel Injection Systems
S-EP08-08.02ILT Evaporative Emissions Controls: Why is there
always a code but never a leak we can find?
S-EP08-09.01ILT Spark Generation: Is a lack of spark sending you
up in flames?
S-EP08-10.01ILT Direct Injection
S-EP08-81.02ILT Duramax Diesel Operation and Diagnosis
S-SS04-01.01ILT Vibration Correction Diagnostics
S-ST10-01.01ILT Supplemental Restraint Systems
New Virtual Classroom Training
Passenger Car All-Wheel Drive (S-MT03-02.01VCT) – This course
discusses the diagnosis of front-wheel and rear-wheel drive passen
-
ger cars with all-wheel drive systems, including diagnosing an AWD
concern on a FWD vehicle and diagnosing a transfer case clutch
calibration resistor circuit concern on a rear-while drive vehicle.
Engines, New and Updates (S-EP08-04.01VCT) – This course
provides information about the 6.2L LT1, 4.3L LV3, 2.0L LUZ, 2.5L
LKW, 3.6L LF3, 5.3L L83, and 6.2L L86 engines, including engine
features, specifications, new technology, and service procedures.
Topics covered include fuel injector fuel rail assembly replacement,
fuel pump replacement, the balance shaft and timing chain assem
-
bly, the intake valve lift control system, the camshaft cover cleaning
procedure, the twist lock injector connector, fuel injection pump
replacement, and timing belt removal and replacement.
For information on the requirements for VCTs, refer to the VCT
User Guide by selecting the Resources icon at the top of the
Training home page.
– Thanks to Greg St. Aubin
Training Schedule
Current Instructor-Led Training (ILT) Courses
The following ILT courses are currently being scheduled:
How to Take ACDelco Training
Go to www.acdelcotechconnect.com and click
the Training tab to log in to the ACDelco Learning
Management System (LMS).
• To launch or enroll in courses in your training
path, open the home page to view your Training
Progress Status Report, select Show Detail, and
then click the course number and title to view
details on a specific course and to launch or enroll
in the course.
• To enroll in an Instructor-Led Training (ILT) course
(ILTs are full-day hands-on classroom courses),
click Take Training > Catalog > Catalog Search and
select Instructor-Led Training under Delivery Type.
• To launch a Web-Based Training (WBT) course
(WBTs are 1- to 4-hour self-guided online courses),
click Take Training > Catalog > Catalog Search and
select Service or Business Web-Based Training
under Delivery Type.
• To launch a TechAssist (TAS) course (TAS courses
are 15- to 20-minute online presentations on a spe
-
cific topic), click Take Training > Catalog > Catalog
Search and select TechAssist under Delivery Type.
• To launch a Simulation (SIM) (SIMs require users
to complete all repairs for a condition), click Take
Training > Catalog > Catalog Search and select
Simulation under Delivery Type.