Installation guide

ManualsBrandsBosch ManualsComputer equipmentMastertech M-VCI

Robert Bosch LLC M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009

M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009 Robert Bosch LLC

Installation Steps | Step 4 | 1211 | Installation Steps | Step 4

Note: The S/N shown should agree

with the S/N on the label of the

M-VCI unit.

Step 4 – Setting up your

M-VCI (Applies to Types I,

II & III) (Clearing Existing

Network Settings)

Click: Network Setup Tab f

f Click: Clear Network Settings

f Click: OK

Wait for the “Conguration f

Complete” Message

Step 4 – Setting up your

M-VCI (Applies to Types I,

II & III) (Conguring Wired

Ethernet Settings)

While in Network Setup:

Click: Wired Ethernet Tab f

Click: Enable Wired Ethernet f

Interface

Note: If your network utilizes

Static IP addresses, do not enable

Wired Interface with Static IP.

Note: This will allow M-VCI to

be connected to any network

Ethernet port if there is limited or

no wireless coverage.

Step 4 – Setting up your

M-VCI (Applies to Types I, II

& III) (Conguring Wireless

Connection Settings)

While in Network Setup:

Click: Wireless (802.11) tab f

Click: Enable Wireless Interface f

Click: Access Point button f

Note: If your network utilizes

Static IP addresses, see

Appendix A.

Step 4 – Setting up your

M-VCI (Applies to Types

I, II & III) (Setting the

Wireless SSID)

Click: Refresh f

Select: Available Network f

Bosch_VCI_AP –

(include underscores)

Click: Congure f

Option: You can manually enter SSID

Bosch_VCI_AP into the text box.

Note: Refer to Appendix D when

dealing with a network with

multiple access points.

Step 4 – Setting up your

M-VCI (Applies to Types

I, II & III) (Setting the

Wireless Encryption)

Verify: Network Authentication f

WPA – Personal –

TKIP –

Enter: security password f

Bosch_VCI_800-321-4889 –

(include underscores)

Click: Next f

Note: Double check password:

Bosch_VCI_800-321- 4889

Step 4 – Setting up your

M-VCI (Applies to Types

I, II & III) (Verifying your

Settings)

Verify Your Settings f

Click: Yes, Select OK f

Wait for the “Conguration f

Complete” Message