Installation guide

Robert Bosch LLC M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009
M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009 Robert Bosch LLC
Installation Steps | Step 1 | 65 | Installation Steps | Step 1
This shows the NETGEAR pre-
congured router installed into a
network (Setup Type II) without
any pre-existing wireless router.
No network changes are necessary
for DSL/cable modem or wired
computers.
This shows the NETGEAR pre-
congured router installed as a
stand-alone device (Setup Type III)
without internet.
Installation Steps
Step 1 - NETGEAR Router
conguration (For: Types I,
II & III) (Getting Started)
Connect the NETGEAR router f
to AC power
Disable the wireless card on f
your computer
Disconnect all wired network f
connections
Connect the router to the f
computer LAN port
f Reboot the computer
(to renew the IP address)
Open your web browser f
Enter http://192.168.1.1 into f
your browser address bar and
press <Enter>
f Enter User Name and Password
User Name: – admin
Password: – password
Note: The router does not need
internet connection at this time.
Step 1 - NETGEAR Router
Conguration (For:
Types I, II & III) (Router
Initialization)
The rst time you log into the
router it will display a greeting
screen, and a prompt For “Smart
Setup Wizard”
Uncheck: Do Not Display This f
Message Again
Click: Close Window f
f Check: No to Setup Wizard
Click: Next f
Step 1 - NETGEAR Router
Conguration (For: Types I,
II & III) (Router Navigation)
Click: Backup Settings f
Step 1 - NETGEAR Router
Conguration (For: Types I,
II & III) (Restore Settings)
Click: Browse f
f Browse to:
Netgear_Cong_A.cfg (File –
for Type I) or
Netgear_Cong_B.cfg (File –
for Types II & III)
Click: Restore f
Wait for the progress bar to f
indicate completion of the
restoration.