Installation Manual

4
1
5
2
3
4
Figure 4.2: Wiring for one set on the run
Callout ﹘ Description Callout ﹘ Description
1 ー Power output 4 ー Control panel
2 ー Transmitter 5 ー Alarm input. The COM and NC terminals
on the unit are the outputs, they connect to a
control panel input.
3 ー Receiver
1
5
4
3
2
3
2
Figure 4.3: Wiring for two sets on a single run
Callout ﹘ Description Callout ﹘ Description
1 ー Power output 4 ー Control panel
2 ー Transmitter 5 ー Alarm input. The COM and NC terminals
on the unit are the outputs, they connect to a
control panel input.
3 ー Receiver
Notice!
The BH12T heater is an optional device. Refer to the BH12T installation instructions (P/N: W.
97.2195) for more information.
Photobeam 5000 Wiring | en 15
Bosch Security Systems, Inc. Installation and Operation Guide 2015.01 | 02 | F.01U.303.478