Operation Manual
Table Of Contents
- Table of Contents
- 1 Browser connection
- 2 System Overview
- 3 Operation via the browser
- 3.1 Livepage
- 3.2 Playback page
- 4 Settings Overview
- 5 Basic Mode
- 6 Advanced General Settings
- 7 Web Interface
- 8 Camera
- 9 Encoder Settings
- 10 Recording
- 11 Alarm
- 12 Setting up VCA
- 14 Network
- 14.1 Network Access
- 14.1.1 Automatic IP assignment
- 14.1.2 IP V4 address
- 14.1.3 IP V6 address
- 14.1.4 DNS server address 1
- 14.1.5 Video transmission
- 14.1.6 TCP rate control
- 14.1.7 HTTP browser port
- 14.1.8 HTTPS browser port
- 14.1.9 RCP+ port 1756
- 14.1.10 Telnet support
- 14.1.11 Interface mode ETH
- 14.1.12 Network MSS [Byte]
- 14.1.13 iSCSI MSS [Byte]
- 14.1.14 Network MTU [Byte]
- 14.1.15 Enable DynDNS
- 14.1.16 Provider
- 14.1.17 Host name
- 14.1.18 User name
- 14.1.19 Password
- 14.1.20 Force registration now
- 14.1.21 Status
- 14.2 Advanced
- 14.3 Multicast
- 14.4 Image Posting
- 14.5 Accounts
- 14.6 IP V4 filter
- 14.1 Network Access
- 15 Service
Camera Browser Interface Camera | en 43
Bosch Security Systems Software manual AM18-Q0649 | v5.8 | 2013.05
8Camera
8.1 Installer Menu
8.1.1 Base frame rate
Select the base frame rate for the camera.
Note:
Shutter times and frame rates are affected by this value.
8.1.2 Camera LED
Disable the Camera LED on the camera to switch it off.
8.1.3 Mirror image
Select On to output a mirror image of the camera picture.
8.1.4 Flip image
Select On to output an upside down camera image.
8.1.5 Reboot device
Click Reboot to restart the camera.
8.1.6 Factory defaults
Click Defaults to restore the factory defaults for the camera. A
confirmation screen appears. Allow 5 seconds for the camera to
optimize the picture after a mode reset.