Installation guide

EN | 15
Bosch Security Systems | 2005-09 | V3.0 Installation and Setup
Installation and Operating Manual | VIDOS IntuiKey
Preparing site maps
For users who work on digital screens, a work area consisting of one or more
site maps can be set up in VIDOS. This work area is typically shown in full-
screen mode. The user can use VIDOS IntuiKey to navigate between the
different site maps.
Each site map is given a number. The procedure for this is as described above
under P
REPARING CAMERAS AND HARDWARE MONITORS. Below, you can see a
typical example of the Properties dialog box for a site map:
Hardware and software monitor windows can also be embedded in the site
maps, on which the user can operate VIDOS IntuiKey to connect cameras or
salvos.
The hardware monitors are given their specific numbers as described above.
The software monitor windows are assigned numbers in the site map editor
using the kbid property. (For details, refer to the separate S
ITE MAPS
documentation).
Note
If several site maps belong to a work area, there may be a monitor window
with the number 1 on each of these site maps – but this monitor number
may only be assigned once within each individual site map.
Administration is easier if you only assign each number once.
Software monitor windows also provide an option for instant replay of
recordings, which can be started and controlled using VIDOS IntuiKey (for
details see I
NSTANT REPLAY AND BACKUP).
Number
This number is entered on the
control panel to call up this site
map.