Installation guide

EN | 10

Installation and Setup Bosch Security Systems | 2005-09 | V3.0

Installation and Operating Manual | VIDOS IntuiKey

Connecting and starting the control panel

Warning!

Make sure that the BOSCH IntuiKey digital control panel you are using has

at least firmware version 1.60. Control panels with older firmware versions

cannot be used in conjunction with VIDOS.

1. Connect a COM port on the PC on which VIDOS is installed to the RS232

serial port on the rear of the control panel using the appropriate cable.

Note

Use a fully occupied serial cable (9-wire) for the connection.

2. Make sure that the power supply unit provided is used to power the control

panel.

As soon as the power supply is connected, the control panel is active.

3. Make sure that VIDOS is started on the PC.

4. Press the Prod key on the control panel.

The control panel starts the search for products with which it can

communicate. VIDOS is found.

In the top left of the soft key display on the control panel, you will find the

option Terminal.

5. Press the Terminal soft key to use the control panel in conjunction with

VIDOS.

The main menu will then appear in the soft key display.

Note

The Keyboard control option allows you to test the control panel. This

option is described in the

DEVICE DOCUMENTATION FOR THE BOSCH

NTUIKEY CONTROL PANEL.