Technical data

52 en | Configuration Integrus

IOM-INT | V1.1 | 2010.12 Installation and Operation manual Bosch Security Systems B.V.

7.2.3 Set network mode

The network mode menu item (4B) is used to enable and disable the optical network

connections. When the transmitter is connected to a DCN Next Generation conference

system, the optical network connections must be enabled.

7.2.4 Set number of channels

Via sub-menu item 4C the number of channels that will be used can be set. Note that the

maximum number of channels depends on the transmitter type (4, 8, 16 or 32 channels) and

the chosen quality modes. When a DCN Next Generation or a DCN system is connected to the

transmitter, the number of channels can be automatically set by the connected system.

- Aux to All The signals on the Auxiliary inputs are

distributed on one carrier to all channels.

- Test A A different test tone is distributed on each

channel. The frequency increases with

increasing channel number. For stereo

channels the tone for left and right will also be

different.

- Slave The radiator signal on the slave input is

looped-through to all radiators.

Menu Item Options Description

4B Network Mode Mode:

- Disabled Optical network connections disabled. Use

this mode when the transmitter is not used in

combination with DCN Next Generation.

- Enabled Optical network connections enabled. Use

this mode when the transmitter is used in

combination with DCN Next Generation.

Menu Item Options Description

4C Nr. of Ch. Nr. of channels