Specifications

D5200 Programmer Operation Manual
Page 5
© 1991-1995 Radionics
74-06176-000-B 9/95
A-5200-030-40
Power Sources
Three sources are available to provide power to the D5200 Programmer: AC, internal
batteries, and a panel power source. The D5200 can operate on any one – or a combination
of – these three sources. The programmer also has an automatic time-out feature which
safely powers down the D5200 after a programmed amount of time.
AC
An EXTERNAL POWER connector is provided for connecting the D5200 to a standard AC
power source using an AC adapter (Radio Shack part# 273-1652A).
Batteries
Four alkaline C cell batteries inside the programmer provides power when other sources are
not available. Tests conducted by Radionics have indicated that the programmer can operate
on high-quality alkaline batteries (with no other power source) for 8 hours of continuous use.
Panel
The D5200 can also obtain power from a connection to a control/communicator.
Specifications
PROGRAMMER
Operating Temperature: 32°F to 122°F
Storage Temperature: -20°F to 150°F
Non-condensing Relative Humidity: 5 to 85% at temperature range of -20°F to 150°F
PROGRAMMER KEYBOARD
Operating Temperature: -40°F to 149°F
Storage Temperature: -40°F to 149°F
Maximum Key Presses (each key): 1.5 million
NOTE: Exposure to heat and direct sunlight exceeding the manufacturer's specifications can
cause discoloration, delamination of the keypad.
EXTERNAL POWER TRANSFORMER
Radio Shack part# 273-1652A: 12VDC, 500 mA
FCC QUALIFICATIONS
Complies with FCC Parts 15 and 68 when connected to a phone network in parallel with a
telephone or other device with ringing detection circuitry (see Figure 27).
FCC REGISTRATION NUMBER: AJ9USA-65062-AL-E
050