Specifications

D5200 Programmer Operation Manual
Page 46
© 1991-1995 Radionics
74-06176-000-B 9/95
A-5200-030-460
Adjusting the LCD Display Contrast
With a small screwdriver, turn the LCD contrast screw clockwise to increase display contrast,
or counterclockwise to decrease contrast. Test the contrast setting by holding down a repeat
key (i.e. scroll the display with the red ↓ key). If the contrast is set incorrectly, the display may
blur when scrolled quickly.
15. Troubleshooting Guide
This chapter contains a list of warning messages that can be displayed on the programmer,
and general programmer problems.
Programmer Problems
LCD Display Blank If the LCD display is blank, but the programmer is emitting normal operating
sounds (tweedle, pip, etc.), turn the LCD contrast adjuster located next to the
display on the inside of the programmer.
Warning Messages
59 SEC TO POWER DOWN The D5200 automatically powers down if no keys have been pressed within the
time programmed in Time Out (SECURITY menu). To prevent the programmer
from powering down, press any key (an arrow key is recommended, since it
will not change data or levels) .
ACCESS DENIED The password used to log on to the programmer has not been given the authority
to access the function.
BAD DATABASE FILE This message is displayed if an attempt was made to copy a record to a disk that
does not contain the associated product handler.
LOW BATTERY This message is displayed approximately one hour prior to low-battery power
down. This message is displayed every 10 minutes until shut down. When this
message is displayed, save the record that is currently open, power-down the
programmer, and replace the batteries. NOTE: Powering up a programmer with
a low battery condition may drain the batteries in less than one hour, depending
upon the quality of the batteries.
**BAD SYSTEM FILE * This message is displayed when the D5200 system file has been damaged.
Press any key to Press any key to configure the D5200 with a new system file. All passwords
default SYSTEM FILE and lockcodes are lost when a new system file is installed, and the programmer
can only be accessed with the default all blank password (simply press the white
ENTER key). Reprogram all passwords and lockcodes (SECURITY menu).
NOTE: This message signifies an unusual event. If this message is displayed,
consider returning the unit to Radionics for repair.
Comm Error Displayed if a communication error disrupts a send (load) or receive (copy)
process.
DISK A (or B) BAD This message is displayed when the internal RAM disk (Disk A) or RAM Card
FORMAT IMMEDIATELY (Disk B) has been damaged. Press any key to access the PRODUCT HANDLERS
Press any key menu. Format the disk (FormatDisk in the SECURITY menu) as soon as
possible . NOTE: This message signifies an unusual event. If this message is
displayed, consider returning the unit to Radionics for repair.