Specifications

A-5200-030-380
© 1991-1995 Radionics
74-06176-000-B 9/95
D5200 Programmer Operation Manual
Page 39
Figure 29: TELCO UPDATE CONFIGURATION
Updating via the Phone
Handlers in one programmer can be updated by a second programmer via the phone (pulse
dialing only). One D5200 is the "Sending Programmer" of handlers and locked records, and
the second D5200 is the "Receiving Programmer". If the Receiving Programmer already has
the handler to be updated, the Sending Programmer transfers only its locked records (i.e.
NEWRECORD) to the Receiving Programmer. If the Receiving Programmer does not
currently contain the handler to be transferred, the Sending Programmer transfers the
handler and all locked records (i.e. NEWRECORD) to the Receiving Programmer. Connect
the SENDING and RECEIVING Programmers to phone lines (TELCO port to phone jack) as
shown in Figure 29, and set up each programmer as described below.
SENDING PROGRAMMER – TELCO
This programmer will be sending the updated handler to the Receiving Programmer.
1. Scroll to UPDATE in the Product Handlers menu using the red ↓ or ↑ keys, and press the
red ENTER GROUP key.
2. Use the red ↓ key to scroll down to the Mode prompt.
To transfer a handler from internal Disk A: Press the SPACE bar until the A→TELCO
selection is displayed.
To transfer a handler from removable RAM Disk B: Press the SPACE bar until the
B→TELCO selection is displayed.
A → TELCO
B → TELCO
EXTERNAL
POWER
COMMUNICATOR AUXILIARY
RS-232
TELCO
D5200
RECEIVING
PROGRAMMER
UPDATE
Phone: [phone]
Mode: TELCO -> A
EXTERNAL
POWER
COMMUNICATOR AUXILIARY
RS-232
TELCO
D5200
SENDING
PROGRAMMER
PHONE NETWORK
PHONE
SPLITTER
UPDATE
Phone:
Mode: A -> TELCO
Necessary only if no other
ringing device on circuit.