Specifications

D5200 Programmer Operation Manual

Page 38

74-06176-000-B 9/95

A-5200-030-380

3. Press the white ENTER key. The message WAITING for Handler Request... is

displayed. When the handler request from the Receiving Programmer is detected, the

Sending Programmer transfers the requested handler. The progress of the handler

transmission is displayed (see Figure 28). If the transfer is successful, the message

UPDATE SUCCESSFUL is displayed. If the transfer is not successful, the message

UPDATE FAILURE is displayed. The cursor returns to the UPDATE menu.

4. To update additional handlers, repeat steps 2 and 3. To return to the Product Handlers

level, press the red EXIT GROUP key.

SENDING 7112

0% 100%

Block:xxx:

Figure 28: SENDING PROGRAMMER UPDATE PROGRESS

RECEIVING PROGRAMMER – RS-232

This programmer will be receiving the handler update from the Sending Programmer.

1. Scroll to UPDATE in the Product Handlers menu using the red ↓ or ↑ keys, and press the

red ENTER GROUP key.

2. Type the handler name (i.e. 7112) at the Handler prompt, and press the white ENTER

key. The cursor moves down to the Include Help prompt.

3. The Include Help entry defaults to No. To include the handler help file in the update,

press the SPACE bar to toggle the entry to Yes. Press the white ENTER key. The cursor

moves down to the Phone prompt.

4. Use the red ↓ key to scroll down to the Mode prompt.

To transfer a handler to internal Disk A: Press the SPACE bar until the RS232→A

selection is displayed.

To transfer a handler to removable RAM Disk B: Press the SPACE bar until the

RS232→B selection is displayed.

5. Press the white ENTER key. The message WAITING for CONNECT to Update

System is displayed. When this handler request is detected by the Sending Programmer,

the Sending Programmer transfers the requested handler. The progress of the handler

reception is displayed (see Figure 26). If the transfer is successful, the message UPDATE

SUCCESSFUL is displayed. The cursor returns to the UPDATE menu. To update another

handler, repeat steps 2 through 5.

If the transfer is not successful, the message UPDATE FAILURE is displayed.

If the handler requested by the Receiving Programmer was not available in the Sending

Programmer, the message HANDLER NOT FOUND is displayed.

6. To return to the Product Handlers level, press the red EXIT GROUP key.

RS232 → A

RS232 → B