Specifications

D5200 Programmer Operation Manual

Page 36

74-06176-000-B 9/95

A-5200-030-360

5. Mode prompt entry:

To transfer a handler to internal Disk A: Press the SPACE bar until the TELCO→A

selection is displayed.

To transfer a handler to removable RAM Disk B: Press the SPACE bar until the

TELCO→B selection is displayed.

6. Press the white ENTER key. The programmer clicks as it dials out, and the message

WAITING for CARRIER is momentarily displayed, followed by the message WAITING

for CONNECT to Update System is displayed. When this handler request is detected

by the Update System, the Update System transfers the requested handler. The

progress of the handler reception is displayed on the programmer (see Figure 26). If the

transfer is successful, the message UPDATE SUCCESSFUL is displayed. The cursor

returns to the UPDATE menu. To update additional handlers, repeat steps 2 through 6.

If the transfer is not successful, the message UPDATE FAILURE is displayed. If the

handler requested by the programmer was not available in the Update System, the

message HANDLER NOT FOUND is displayed.

7. To return to the Product Handlers level, press the red EXIT GROUP key.

RECEIVING 7112

0% 100%

Block:xxx:

Figure 26: "RECEIVING PROGRAMMER" UPDATE PROGRESS

Programmer Tip – Updating Multiple Programmers

The time required to updatehandlers in a programmer depends upon the interfaced

used (see Figure 23). Since it is much quicker to update a D5200 via the RS-232 serial

interface, Radionics recommends updating only the first programmer via the phone

(Telco) lines, and updating additional programmers from the first programmer via the

RS-232 interface (see "Updating Via RS-232" on the following pages).

TELCO → A

TELCO → B