Specifications

A-5200-030-320
© 1991-1995 Radionics
74-06176-000-B 9/95
D5200 Programmer Operation Manual
Page 33
10. Updating Handlers
The update feature of the D5200 can be used to add product handlers to the programmer,
update existing programmer handlers, and copy locked records from one programmer to
another. Handlers can be added and updated via the phone lines at 300 baud using the
programmer TELCO connector, via a serial interface at 19.2k baud using the RS-232
connector, and between internal Disk A and removable RAM Disk B within the programmer
(see Figure 22). The time required to updatehandlers in a programmer depends upon the
interfaced used (see Figure 23). Since it is much quicker to update a D5200 via the RS-232
serial interface, Radionics recommends updating only the first programmer via the phone
(Telco) lines, and updating additional programmers from the first programmer via the RS-
232 interface.
NOTE: This feature is password dependent . If the programmer is logged onto with a
password that does not have the authority to update, the message ACCESS DENIED is
displayed when trying to access this feature.
PRODUCT
HANDLER
D2071
D4112
D6112
D636
D7112
D8112 SERIES
6:00
10:21
12:49
5:24
:
*37:00
PHONE UPDATE
WITH HELP
00:13
00:23
00:29
00:15
:
*1:33
RS-232 UPDATE
WITH HELP
PHONE UPDATE
WITHOUT HELP
RS-232 UPDATE
WITHOUT HELP
4:41
8:52
8:23
4:46
15:13
*28:00
00:11
00:15
00:20
00:10
00:34
*1:10
NOTE: Phone times shown above are for "clean" phone lines. Line noise can increase the update time.
* 8112 Times are best estimate at time of printing. Data not available for blank entries.
Figure 22: UPDATE METHODS
SENDING
RECEIVING
SENDING
RECEIVING
INTERNAL DISK
RADIONICS PHONE
UPDATE SYSTEM
D5200 (local)
D5200 (local)
D5200 (phone)
D5200 (phone)
FROM
DISK
D5200
D5200
D5200
D5200
D5200
DISK A
TO DISK B
B->A
TELCO->A
A->RS232
RS232->A
A->TELCO
TELCO->A
A->B
TELCO->B
B->RS232
RS232->B
B->TELCO
TELCO->B
Figure 23: UPDATE TIMES (MINUTES:SECONDS)